Frigidaire Ice Maker Not Working
Most ice makers stop because water is not reaching them or the freezer is not cold enough, not because the ice maker itself has failed. Confirm the freezer is at or below 10 degrees Fahrenheit, check that the supply valve is open and the water filter is not overdue, then look for a frozen fill tube — the single most common cause.
Typical repair
$225–$520
incl. $75–$120 call-out
Usual part
Ice maker assembly / water valve
$150–$400 parts & labour
Safe to check yourself
4 of 6
causes, before calling out
Want it diagnosed today?
1-888-298-3714Why a Frigidaire refrigerator stops ice maker not working
Ordered by how often each one turns out to be the cause.
Freezer is not cold enough
You can check thisIce makers use a thermostat that must reach roughly 10 degrees Fahrenheit before the harvest cycle starts. A freezer running warm simply never triggers it.
What to do: Put a thermometer in the freezer and confirm it holds at or below 10 degrees Fahrenheit.
Frozen fill tube
You can check thisThe small tube feeding the mould freezes into a plug, usually after a slow leak at the inlet valve. Water then cannot reach the tray at all.
What to do: Look for a plug of ice at the tube where it enters the ice maker. Clearing it with warm water is a temporary fix — the cause is usually the inlet valve.
Water filter overdue or clogged
You can check thisA restricted filter drops flow below what the inlet valve needs to fill the mould, so cubes come out hollow, small, or not at all.
What to do: Replace the filter if it is over six months old, then discard the first few batches of ice.
Supply valve closed or line kinked
You can check thisThe saddle or shut-off valve behind the refrigerator gets knocked closed when the unit is moved, or the copper line kinks.
What to do: Confirm the shut-off valve behind the unit is fully open and the line is not crushed against the wall.
Failed water inlet valve
TechnicianThe solenoid valve that admits water to the ice maker fails electrically or silts up, so the mould never fills.
How it is diagnosed: A technician checks for voltage at the valve during the fill step and tests the solenoid.
Failed ice maker module or thermostat
TechnicianThe module drives the harvest cycle. When it fails the tray fills but never ejects, or nothing happens at all.
How it is diagnosed: A technician runs the module through a forced harvest cycle to isolate it from the water supply side.
Before you start
- Unplug the refrigerator before removing the ice maker or working near its wiring.
- Turn off the water supply before disturbing the fill line, and have a towel ready — the line stays pressurised.
- Do not chip ice out of the mould with a knife or screwdriver. The mould and its heater are easily punctured.
- Never use a heat gun to thaw a fill tube; warm water is enough and will not distort the plastic.
What is specific to Frigidaire
Frigidaire ice makers commonly fail at the water inlet valve and the ice maker assembly, and the water dispenser usually stops at the same time when the valve is at fault.
All Frigidaire refrigerator repairWhat the repair costs
| Diagnostic call-out | $75–$120 |
|---|---|
| Ice maker assembly / water valve — parts and labour | $150–$400 |
| Typical total | $225–$520 |
| Comparable new unit | $800–$2,500 |
| Typical service life | 13 years |
Typical national ranges, not a quote. True Appliance Repair connects you with independent local technicians — the price depends on your model and what the technician finds.
Common questions
Why is my Frigidaire refrigerator maker not working?
Freezer is not cold enough is the most common cause. Ice makers use a thermostat that must reach roughly 10 degrees Fahrenheit before the harvest cycle starts. A freezer running warm simply never triggers it.
How much does it cost to fix a Frigidaire refrigerator that is maker not working?
Expect roughly $225–$520 for a typical repair, covering the ice maker assembly / water valve plus labour and the $75–$120 diagnostic call-out. Parts and labour alone run $150–$400. These are typical national ranges, not a quote — the actual price depends on your model and what the technician finds.
Is it worth repairing, or should I replace it?
A repair at $225–$520 is well under half the $800–$2,500 cost of a comparable new unit, so repair is usually the economical choice within the 13-year typical service life. Past that age the calculation shifts toward replacement.
Can I fix this myself?
4 of the 6 common causes are safe to check yourself, starting with freezer is not cold enough. The remainder involve testing components under power and should go to a technician. Unplug the refrigerator before removing the ice maker or working near its wiring.
How long does the repair take?
Most refrigerator repairs of this type are completed in a single visit once the fault is confirmed, provided the part is a common one. Parts for this repair are usually stocked or available quickly.
Is there anything specific to Frigidaire with this fault?
Frigidaire ice makers commonly fail at the water inlet valve and the ice maker assembly, and the water dispenser usually stops at the same time when the valve is at fault.
Still not fixed?
Tell us what your Frigidaire refrigerator is doing and we will connect you with a local technician who repairs Frigidaire refrigerators every day.
1-888-298-3714